Phase rotation testing is being revolutionized by the Kewtech KEW8035 Phase Rotation Tester, which uses NEW technology. Phase rotation may be found with this special tester without requiring direct contact between the probes and live wires, making testing considerably safer. The magnet on the back of the device can also be used to fasten the KEW8035 to a metal panel.
- Phase-to-phase AC voltage range: 70–1000 V (sine wave, continuous input)
æ2.4 - 30mm insulated cables is the clamp diameter range.
Range of frequencies: 45–66 Hz
Phase rotation (clockwise): An intermittent buzzer, green LEDs that "
- rotate"
- in a clockwise direction, and a green symbol "
- CW"
- light up.
Phase rotation (counter-clockwise): a continuous buzzer, red arrow LEDs that "
- rotate"
- counter-clockwise, and a red symbol "
- CCW"
- that lights up.
LEDs with the "
- Super Brightness"
- function serve as a visual cue.
Operating parameters: 80% humidity (no condensation), -10 to 50°C
Conditions for storage: -20 to 60°C, 80% relative humidity (no condensation),
Power source: Four alkaline (LR6) batteries, enough for about 100 hours of continuous operation.
Auto shuts off after ten minutes.
Warning light for low battery voltage: The power LED blinks.
Double-insulated cables serve as test leads.
L1(U) stands for red, L2(V) for white, and L3(W) for blue.
Standards: Pollution degree 2, IEC61557-1, -7, CAT IV/600V, Cat III/1000V, and IEC61010-1
Elasticity: 112 x 61 x 36 mm
380g in weight
- NEW technological advancements boost security.
special capacity to conduct tests without putting probes in direct touch with live wires.
Cables with an æ of 2.4 to 30mm can be clipped using insulated croc clips.
Logical auditory tones and rotational LED illumination serve as indicators of phase rotation.
Broad measurement range of 70V to 1000V AC is suitable for three phase setups.
Magnet on the back makes it possible to fasten to a metal panel.
Meets IEC61010-1 requirements for Cat IV/600V and Cat III/1000V
