The Martindale CD1000 Cable Detector Kit is perfect for finding fuses and breakers on active or inactive circuits, as well as for tracing wires inside walls and beneath floors. Finding breaks and open circuits in cables and electrical floor heating systems is made easier for electrical experts with its assistance. It is applicable to the tracing of heating and water pipes made of metal. Through the use of cutting-edge digital circuit technology, the transmitter modifies an AC voltage and transfers it to the target cable, creating an alternating electric field. The receiver head picks up, magnifies, and decodes the alternating field. One can locate a fuse, trace the path of a cable, or identify a break in a cable or conductor by localizing the maximum signal intensity observed. One transmitter and one receiver in a case, a set of test leads with crocodile clips, an earthing rod, batteries, and instructions are included with the CD1000 package.
- Electrical Specifications
Transmitter
Frequency of output carrier signal: 125 kHz
Voltmeter operation: Range: DC &
- AC rms (12V to 400V
- 50Hz to 60Hz)
Precision: ± 2.5 percent
400V DC or AC rms is the maximum input voltage.
Receiver Tracking Depth:
Single pole: approximately 2 meters
- dual pole: approximately 0.5 meters
2.5 m approximate single loop line
- UAC 0.4 m approx.
General Specifications
The test leads are in compliance with BS EN61010-031 CAT III 1000V, 10A EMC standards. Meets BS EN61326 standards
Climate and Humidity
In operation: 0°C to 40°C at 80% relative humidity (non-condensing).
Storage: -20°C to 60°C at most, 80% relative humidity (non-condensing)
Reach as high as 2000 meters
Power
One 9V IEC 6LR61 battery powers the transmitter.
6 x 1.5V AAA, IEC LR03 batteries for the receiver
Present-day usage
Transmitter: around 31 mA at minimum, 115 mA at maximum
Receiver: around 32 mA at minimum, 89 mA at maximum
Auto off time (receiver only): around ten minutes
Measurements
Sender dimensions: 190 x 89 x 42.5 mm
Empfänger: 78 x 38.5 x 241.5 mm
Weight
Transmitter weight: around 360g (batteries not included)
about 420g (batteries included)
Receiver weight: about 280g
- batteries not included.
about 350g (batteries included)
Safety
Transmitter: Complies with BS EN61010-1 Class II Double Insulation, CAT III 300V
Degree of pollution: 2.
Receiver
complies with BS EN 61010-1 Class II Double Insulation CAT III 600V Pollution degree: 2
- Adjusting the sensitivity of the receiving signal manually or automatically
Clear signal identification is guaranteed by a proven digitally coded sender signal.
functioning on live/dead circuits without the need for further instruments
Transmitter for sending code and level that has an LCD display
Signal coding shown to facilitate using several transmitters
LCD display with backlighting
indicator of live voltage
Signal intensity Mute feature
Turn off automatically
An extra torch light for use in dimly lit areas
Multiple applications can be made of extra transmitters.
